King-electric FCS11 Instant Alert Monitor Manuel d'utilisateur télécharger pdf

OPERATING INSTRUCTIONS

King Electric’s Instant Alert Monitor is designed to alert the installer if continuity in the heating

wire is broken by cutting the wire or if there is a short circuit between the ground and heating

wires. Connect the Instant Alert Monitor to your Floor Heating Cable or Mat System BEFORE

starting installation and leave it connected until the job is COMPLETE.

PREPARATION

1. Remove the battery compartment cover on the back of the Instant Alert Monitor. Insert two

(2) AAA size batteries into the compartment. Make sure the batteries are installed in the correct polarity

according to the symbols in the battery compartment.

2. Replace the battery compartment cover. Switch the unit to the “ON” position to activate Instant Alert

Monitor

3. Since the Instant Alert Monitor is not connected to a mat or Floor Heat Cable system, the alarm should

sound and the red alarm indicator light should be lit. If the red alarm indicator light does not go on, and

you do not hear the alarm sound, then remove the battery compartment and inspect the battery

connections. Correct the polarity or replace the batteries.

4. Turn the Monitor “OFF”

INSTALLATION

1. Loosen the 3 terminal screws

2.a For One Cable or Mat: See FIG 1

a. Insert the ground wire from the cable into the E

terminal on the front of the device and tighten

the E terminal screw.

b. Insert the one of the two heating lead wires

from the cable (black and white (120V) or

black and red (240V)) into the L1 terminal from

the front of the device. Insert the other into the

L2 terminal. Tighten the L1 and L2 screws.

2.b For up to Three Cables or Mats: See FIG 2 or

FIG 3.

a. Insert the Black heating lead wire from the

heating cable into the L1 terminal from the

front of the device and tighten the screw.

b. Insert the White for 120V or Red for 240V

heating lead wire from a DIFFERENT heating

cable into the L2 terminal and tighten screw.

c. Connect the remaining heating lead wires so

that the mats are connected in series.

d. Connect all ground wires together and connect

them to the E terminal and tighten screw.

3. A green light indicates that the device is operating

properly and does not sense damage in the cable.

800-603-5464 king- electric.com

OFF

1 2

WARNINGS 2

Résumé du contenu

Page 1

OPERATING INSTRUCTIONS King Electric’s Instant Alert Monitor is designed to alert the installer if continuity in the heating wire is broken by cu

Page 2 - WARNINGS

OPERATION IMPORTANT: Make sure that the Floor Heating Cables or Mat systems which will be monitored ARE NOT connected

Commentaires sur ces manuels

Pas de commentaire

King-electric FCS11 Instant Alert Monitor Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques King-electric FCS11 Instant Alert Monitor. King Electric FCS11 Instant Alert Monitor User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour les appareils électriques King-electric FCS11 Instant Alert Monitor